Configuring The Audio Outputs On The Rear (Ext. Out Config Function) - Viscount Ouverture Guide De L'utilisateur

User Guide
the screen comprises four sections:
o MODE: selects the type of wind-chest from:
- C – C# (alternate keys)
- MONO
- DOUBLE CUSP
CUSP
-
- DOUBLE WING
WING
-
o FROM and TO: they select the limits of the area, set in outputs, within which the wind-chest is to be
located. The value is set as [output number-position between two outputs], bearing in mind that there are
four positions between one output and the next (2-4-6-8 on the display).
A value of 40 means that the end of the range (FROM or TO) is on output [4]; a value of 82 means that
the FROM or TO point is between output [8] and [9], close to [8] since it is in the first fifth of the area
between output [8] and output [9]. The screen previosly shown refers to a peaked wind-chest placed
between output [1] and a position between outputs [4] and [5].
o [position indicator]: it consists of small rectangles located above the drawing of the wind-chest and
indicates that the zone is displaying the part below the total number of outputs.
o [wind-chest on outputs]: in the bottom of the screen, it provides a graphic illustration of the wind-
chest with the references to the outputs being used, to give an immediate picture of its position and the
outputs which will carry the notes, in accordance with the wind-chest configuration.
To view the setup of another stop, simply activate the draw-stop / tab or press [EXIT] to quit the function.
In both cases the set-up just created is saved automatically.
9.2 CONFIGURING THE AUDIO OUTPUTS ON THE REAR
(EXT. OUT CONFIG function)
Thanks to this function, the PROGRAMMABLE OUTPUTS can be configured, so as to manage the
Antiphonal signal (controlled through the AMPLIFICATION tabs), the general signal or just the reverberated
signal of the instrument. Select the EXT. OUT CONFIG. field under the SET-UP menu; this pop-up message
will appear:
which means that the external panning (see par- 9.1) of certain stops might be modified automatically.
Stops placed between outputs [2] and [3] (in organs equipped with 4 outputs), [8] and [9] (in organs equipped
with 12 outputs) or between [16] and [17] (in organs equipped with 20 outputs), and/or outputs set as
GENERAL or REVERB, will be automatically set as Mono on the first output of the previously configured
panning. Press [EXIT] to abort the automatic panning adjustment and return to the SET-UP menu.
Press [ENTER] to confirm - the display will show the video page shown on the next page.
19
Viscount Ouverture