Extremis AMAi Mode D'emploi page 51

REPLACING A WOODEN PART
Hey! You don't need to be an engineer to understand
our products. And you don't even need to be great
at DIY to replace a part. Do make sure that you can't
repair the damage simply by sanding the slat.
Powder coating
CLEANING
Regularly
Use Extremis Multicleaner, a 100% biodegradable
detergent or common kitchen cleaning products.
Avoid using aggressive products. These surfaces are
best cleaned with a neutral cleaning product diluted
in water.
REMOVING STAINS
Only if nothing else helps
The magic eraser gets rid of most stubborn stains
without effort. Only if stubborn stains remain visible
after treatment according to the instructions, you
can use the Extremis Magic Eraser sponge. This
sponge is made of melamine resin and wears away
with use. The sponge is very easy to use and gives
results up to 26 times faster than a traditional mi-
crofibre cloth. The magic sponge is the solution for
getting rid of stubborn stains such as felt-tip pens,
grease, scuff marks, limescale marks or coffee and
tea stains. The magic sponge can be used on tar-
paulin fabric, plastic profiles, glass, steel, chrome,
aluminium, porcelain, artificial leather and many
types of floor.
REPAIRING DAMAGED POWDER COATING
When damaged
The impact of sharp objects can damage the
coating. Scratches or dents can be touched up with
our paint pens. However this only camouflages the
scratches without removing them.
Soft desktop
CLEANING
Regularly
Remove dust and fingerprints using a microfibre
cloth. Remove small stains using a cleaning cloth
and spray cleaner/indoor surface cleaner.
Clean badly soiled panels wet all over. Use a cle-
aning cloth and water containing indoor surface
cleaner to wet the surface. Then dry with a well-rin-
sed and wrung-out cloth.
REMOVING STAINS
Only if nothing else helps
Remove stains as soon as they occur! Remove cof-
fee, tea, alcohol immediately before the substances
begin to act on the table top. Take precautions by
using coasters.
Oak veneer
CLEANING
Regularly
Dust regularly using a lightly dampened cloth in the
direction of the wood grain, never across the grain.
Wipe dry with a soft cloth immediately afterwards.
Do not use too much water and, above all, do not le-
ave any residual water. Do not use abrasive cleaning
agents or aggressive solvents!
In case of spillage of soft drinks, beer, coffee, tea,
wine, etc. and even water
Soak up the liquid immediately with a damp cloth
and dry the area with a dry cloth or chamois leather.
Use a soft cloth and particularly not paper towels.
These can scratch the surface. Shrinkage or staining
caused by moisture are therefore not covered by the
guarantee.
Watch the maintenance video on
our website:
www.extremis.com/maintenance
51