Commissioning; Communication; Pc Software Installation - Endress+Hauser Ecograph T RSG30 Mode D'emploi Succinct

Commissioning and operation
5.3

Commissioning

Once the operating voltage is applied, the display lights up and the unit is ready for operation.
• If you are commissioning a unit that is already configured, measuring is immediately started
in accordance with the settings. The values of the display group currently configured appear
on the display.
• When you first commission the unit, program the set up in accordance with the description
in the Operating Instructions on CD-ROM, chapter 6.3.
5.4

Communication; PC software installation

!
Note!
The current PC operating software (CD-ROM supplied) must be installed to be able to establish
communication between the unit and the PC (minimum V1.23.0.0).
5.4.1 Installing the provided PC software
!
Note!
The "Arial Unicode MS™" font must be installed on your PC to operate the provided PC
software. Otherwise certain characters might be displayed incorrectly or not at all. Check this
on your PC under "Control Panel - Fonts". If this font is not installed, please refer to your
Microsoft Office
!
Note!
Administrator rights are required!
1. Install the supplied PC software on your computer. The program's Operating Instructions
can be printed out after installation, if required.
2. After the successful installation you can call up the program under "Start - Programs".
5.4.2 Communication via USB / USB driver installation
Once the provided PC operating software has been installed successfully, the unit can be
connected to the PC with a USB cable. The operating system automatically recognizes the new
USB unit.
!
Note!
Proceed as follows to then install the USB driver (depends on operating system):
1. The Windows prompt "Should a connection be established with Windows Update to look
for software?" appears. Click "No, not this time" and then "Next".
2. The "What do you want the wizard to do?" window appears. Select "Install the software
automatically (Recommended)" and then click "Next".
You can now start the provided PC software to establish communication with the unit.
34
®
or Microsoft Windows
®
manual.
Multi Channel Recorder