Transportation - WAGNER WallPerfect PowerRoll System Mode D'emploi D'origine

PowerRoll System
If you have tapering corners, remove the
i
spacer from the side frame to ensure
a clean finish. Remove the spacer by
pulling it off in an upward direction.
Put the spacer back in place by pushing
the foot into the opening in the side frame
and then pressing the spacer firmly into
position.
•
Move the roller evenly up and down a few times to ensure the paint covers the area
well.
•
Wipe the exterior of the side frame occasionally as you work to prevent drips of paint
getting on to areas that should not be coated.

transportation

Important. The bucket handle must be between both fixtures. Otherwise the
bucket could be tipped by the weight of the PowerRoll system when being
transported and leak paint.
•
Once the device is attached to the paint bucket, you can carry it easily together with the
bucket. check that the device is securely attached to the bucket before it is lifted
by the handle.
•
Do not carry or pull the device by the hoses to avoid any damage.
GB
19