Bosch WEU GCM 12 Professional Notice Originale page 27

OBJ_BUCH-1040-002.book Page 27 Friday, August 12, 2011 3:32 PM
Sawing Workpieces of the Same Length (see figure G)
The material stop 44 can be used for easily sawing workpiec-
es to the same length.
– Move the length stop 44 on the extension bar 43 toward
the saw blade to the desired clearance.
Special Workpieces
When sawing curved or round workpieces, these must be es-
pecially secured against slipping. At the cutting line, no gap
may exist between workpiece, fence and saw table.
Provide for special fixtures, if required.
Replacing the Insert Plate (see figure O)
The red insert plate 8 can become worn after long use of the
power tool.
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two different ways:
– Placed against the fence
– Lying flat on the saw table.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Bevel angle
Floor strip/moulding
Inner corner Horizontal mitre angle
Positioning of work-
piece
The finished work-
piece is located...
Outer corner Horizontal mitre angle
Positioning of work-
piece
The finished work-
piece is located...
Bosch Power Tools
Replace defective insert plates.
– Bring the power tool into the working position.
– Unscrew screws 48 with the provided Phillips screwdriver
21 and remove the old insert plate.
– Insert the new insert plate and screw in all screws 48
again.
– Set the vertical bevel angle to 0° and saw through the in-
sert plate.
– Afterwards, set the vertical bevel angle to 45° and saw into
the cut again.
This procedure achieves that the insert plate is as close as
possible to the teeth of the saw blade without touching it.
Always make trial cuts with the mitre angle setting first on
scrap wood.
Placed
against the
fence
0°
Left side Right side
45° left 45° right
Bottom edge on Bottom edge on
saw table saw table
... to the left of the ... to the right of the
cut cut
45° right 45° left
Bottom edge on Bottom edge on
saw table saw table
... to the right of the ... to the left of the
cut cut
English | 27
Lying flat on
the saw table
45°
Left side Right side
0° 0°
Upper edge against Bottom edge
the fence against the fence
... to the left of the ... to the left of the
cut cut
0° 0°
Bottom edge Upper edge against
against the fence the fence
... to the right of the ... to the right of the
cut cut
1 609 929 T11 | (12.8.11)