Safety Information; Montage - AL-KO AK 301 Mode D'emploi

Profi AK 301_351

Safety Information

Danger!
Risk of accident if the ball coupling becomes
detached during the drive!
After each coupling, make sure the ball coupling
is f rmly seated in the ball on the towing vehicle!
Safety-related component!
We recommend installation by a spe-cialized
shop.
The ball coupling should be used only with nballs 50
„
according to EC Directive 94/20.
For clutch type, see 8:
„
Observe restricted swivel range.
Do not stand on the handle.
„
Components may be damaged.

Montage

The camera symbol refers to illustrations, page 3.
Delivery capacity
Ball coupling Typ AK 301
Screw material
Spacer hoop
Assambly bolts
Available accessories
Lock, Soft-Dock (see main catalogue 365773)
„
The damper is attached to the fixing screw. For
an easier assembly, an assembly bolt is provided.
Mounting
Caution!
Only use self-locking nuts once.
Tightening moment
M12 - 8.8
M16 - 8.8
1361617_f
AK 351
M12 M12 M16
2x 2x
1x 1x
86 Nm
210 Nm
Horizontal screw fitting (
1. Slacken self-locking nuts.
2. Knock hexagon screw through (
sembly bolts ( 2 -2) included and leave it in the
tow bar.
3. Pull hexagon bolt ( 2 -3) out and remove fitted
ball coupling drawbar.
4. Push new ball coupling onto the drawbar, so that the
fastening drill holes match.
5. Draw out the hexagon screw with the assembly bolt
inserting the damper
6. Twist new self-locking nuts in place an tighten
7. After the assembly, push and pull the tow bar to
check it.
If you feel resistance in both directions, the damper
is fitted.
Cross screw fitting (
3)
1. Slacken self-locking nuts.
2. Knock screw ( 3 -1) through with the assembly
bolts ( 3 -2) included and leave it in the tow bar.
3. Pull screw ( 3 -4) out and remove fitted ball cou-
pling drawbar.
4. Push new ball coupling onto the drawbar, so that the
fastening drill holes match.
5. Draw out the hexagon screw (
sembly bolt ( 3 -2) inserting the damper.
6. Fit the enclosed profile disc (
screw ( 3 -1).
7. Twist self-locking nuts in place an tighten.
8. After the assembly, push and pull the tow bar to
check it.
If you feel resistance in both directions, the damper
is fitted.
GB
2)
2 -1) with the as-
3 -1) with the as-
3 -3) on the vertical
9