Functions - Honeywell PEHA Compact 952 JRM Mode D'emploi

FunCTIOnS

Function Description
The JRM can control 12 servo powered blinds, shutters and awnings (M0-11). They can be variably assigned to 3 groups (0-2).
Manual operation is performed locally, centrally or in groups using dual buttons. Programmed timers can activate the outputs
(motors) at specific times. In addition, they can be activated by sensors, depending on the level of daylight or the weather.
General
– The assignment of the outputs to the inputs is fixed and electrically locked.
– All motors are in idle state following a power cut.
Pushbutton mode A long press of the pushbutton causes the shutter to move UP or DOWN for the set time. A short button press stops the
Shutter shutter. Jog mode is not possible.
A long press of the pushbutton causes the blind to move UP or DOWN for the set time. A short button press stops the blind.
The slats can be adjusted in jog mode.
Pushbutton mode
Blind
Note : After a pushbutton has been pressed manually, the sun sensor is ignored until the blind has moved UP to the top
(e.g. with central UP)!
A long press of the pushbutton causes the awning to open or close for the set time. A short button press stops the awning.
Pushbutton mode
Jog mode is not possible. When the awning is closed without stopping, a configurable adjustment time (0–5 s) serves to
Awning
reduce the load on it.
GB-20