Use Tempo; Click Mode; Map (Drum Map) Group; Voice - Yamaha DTXPRESS II Mode D'emploi

4-7. Use Tempo

This function sets the tempo of a song to either change each time
to its default tempo, or remain unchanged at the currently set tempo
when the song is switched.
UT SEQ SETUP

Use Tempo=

q Use Tempo
song:
Changes the tempo of the song to its default tempo when
the song is switched.
global: The tempo remains unchanged at the currently set tempo
when the song is switched.

4-8. Click Mode

This sets whether or not the click voice will automatically sound
during song playback.
UT SEQ SETUP
ClickMode=manual
q ClickMode (Click Mode)
manual: The [CLICK] button will control on/off operation of the
click sound.
sync:
The click will sound during song playback, but will not
sound when the song is stopped. The [CLICK] button
can also be used to control on/off operation of the click
sound.
song q
q

5. MAP (Drum Map) Group

This sub-mode is used to edit the User Drum Map. This mode is
divided into the following 9 pages.

5-1. Voice ................................................................ 35

5-2. Volume, Pan .................................................... 36
5-3. Tuning .............................................................. 36
5-4. Layer Balance .................................................. 36
5-5. Decay, Cutoff Frequency ................................. 36
5-6. Reverb Send .................................................... 36
5-7. Alternate Group, Key Assign Mode ................. 37
5-8. Key Off Enable ................................................ 37
5-9. Map Copy ........................................................ 37
* When a User Drum Kit (No. 49-80) is selected, the User Drum
Map is the data that is used to set the note number's voice, etc.,
that is not assigned to the drum kit's pad input. Therefore, when a
preset drum kit is selected the User Drum Map will not be used
(the preset drum map will be used) so settings for functions [5-1]
to [5-8] that appear in the display can not be carried out.
UT MAP N=
( Preset Map
Also, settings cannot be carried out for the following functions [5-
1] to [5-8] when the note numbers for the currently selected drum
kit are already assigned/set.
UT MAP N=
( Drumkit Data )

5-1. Voice

This creates a list that assigns a drum voice for each MIDI note
number. Which MIDI note number q will be received and which
drum voice w will be sounded.
UT MAP N=
=K/000 NoAssign
w e
q N (MIDI Note Number)
[Range] 0-127 (C-2 to G8)
Sets the MIDI note number. Displays the note number and note
name.
* According to the setting of the Utility mode's [2-1. Learn Mode]
(P. 29) you can appoint the MIDI note number with key on input
from the MIDI IN/TO HOST jacks.
w Voice Category
[Range] K, k, S, s, T, t, C, H, P, E, e, L, m
Selects the drum voice category.
Refer to Drum Kit Voice Edit Mode's [1-1. Voice] (P. 17).
Utility Mode
0C -2
)
0C -2
0C -2 q
35