Important; Accessories - Genesis GPCS535CK Manuel D'utilisation

CUTTING WITH THE MITER BASE (FIG 15)
A Miter Base is included to make accurate miter cuts.
• Position the miter angle scale and base. Set the desired miter
angle. Adjust the extendable fence to support the workpiece.
Place the miter base on a flat surface.
• Draw a desired cutting line on the workpiece.
• Insert the workpiece in the miter base. The reference edge
needs to be tight against the miter fence.
• Choose the correct saw blade for the material to be cut and
change to it. Set the blade cutting depth (See "Setting the
Cutting Depth" section) to the maximum 1-1/8". Place the
saw on the miter base guide rails.
• Turn on the laser. Adjust the workpiece to make sure the laser aligns with the desired the cutting line. Secure
the workpiece in place with the clamp.
• Depress the lock off / plunge release button. Switch the tool on and wait a moment for the blade to run up to
full speed. Plunge the blade into the material slowly and gently, but firmly. Then push the tool forwards along
the guide rails (Never draw the tool backwards).
• Once the finish line has been reached, keep switched on for a few seconds extra to allow the dust to clear
from within the tool.
CUTTING WITH RIP CUTTING TRACK (OPTIONAL) (FIG 16, 17)
An optional Rip Cutting Track System (GAPCS203) is available (not included) to make long accurate straight rip
cuts. To use the tool with the rip cutting track system, follow the steps below.

IMPOrTANT!

The workpiece must have a flat surface. Otherwise the cutting process will not be stable
and will lead to poor cutting accuracy.
• Assemble the tracks.
• Stabilize the track on the workpiece.
• Mount the plunge saw in the track by inserting the edge of the
base plate into the slot on the track.
• Align the indicator line on the base plate to the cutting line
marked on workpiece.
• Secure the track by using the G-Clamps provided with the
track system.
• Plug the tool into a power source. Depress the lock off / plunge
release button. Switch the tool on and wait a moment for the
blade to run up to full speed. Next plunge the blade into the
material slowly and gentaly, but firmly. Then push the tool
forward along the track. (Never draw the tool backwards.)
• Once the cut has been finished, lift the tool from the work
surface before switching off.
• The rubber will be cut off during first cutting. This is normal.

ACCESSOrIES

recommended accessories for this tool are the GENESIS TrAKrUNNEr™
accessories. Please refer to "Genesis Trakrunner Accessory reference Guide" sheet
enclosed for details.
Plunge Circular Saw with Miter Base
Operator's Manual
FIG 15
FIG 16
FIG 17
GPCS535CK