Table Des Matières; Theft Protection - Sony Aiwa CDC-X30MP Mode D'emploi

TABLE OF CONTENTS
THEFT PROTECTION .............................................. 2
BASIC OPERATION, AUDIO AND CLOCK
ADJUSTMENT ..................................................... 3
RADIO OPERATION ................................................. 4
CD PLAYER OPERATION ........................................ 5
AUXILIARY EQUIPMENT ......................................... 9
OTHER FUNCTIONS ................................................ 9
CARD REMOTE CONTROL ................................... 10
TROUBLESHOOTING ............................................ 11
MAINTENANCE ...................................................... 11
SPECIFICATIONS .................................................. 11
Note
Some buttons are assigned two or more functions.
For detailed descriptions, refer to the related pages.
Resetting the unit
Before operating the unit for the first time or after
replacing the car battery, you must reset the unit.
Press the reset button with a pointed object such as a
pencil.
Front panel detached
Reset button
Note
Pressing the reset button will erase the clock and some
memorized functions.
DEMO (Demonstration) mode
The unit has an extra display (DEMO) mode which
demonstrates the illumination modes of the unit. The
unit switches to DEMO mode automatically if you turn
the unit on and leave it as it is for 5 seconds after all the
connections have been completed.
To cancel DEMO mode
1
During DEMO mode, press and hold Jog dial (PUSH-
SOURCE) until "ILL" appears on the display.
2
Press + or - to select "DEMO".
3
Turn Jog dial to select "OFF."
To resume DEMO mode, select "ON" in step 3.
(See the illustration on page 3.)

THEFT PROTECTION

Take the front panel with you when leaving the car, and
keep it in the supplied carrying case.
Detaching the front panel
Before detaching the front panel, remove the CD to
prevent possible damage to the unit.
1
Press z to remove the CD.
2
Press and hold PWR/ATT until the unit turns off.
3
Press %. (Hold the panel with one hand to prevent
accidentally dropping it.)
4
Remove the panel.
Attaching the front panel
1
Engage the left side of the front panel to the left catch
on the unit.
2
Push the panel forward until it locks. Be sure not to
press any buttons while you are attaching the panel.
Note
Do not touch the connector on the reverse side of the
front panel. This could cause a poor or faulty connection.
2
ENGLISH