Medion MD 30262 Mode D'emploi page 34

AUTO:
Your device will recognise the type of signal at the respective entry socket automati-
cally.
PC:
your device will expect an input signal from the video adapter of your PC at the re-
spective input socket in this setting. Please pay attention to the correct selection and
setting of the output of your video adapter.
VIDEO:
Your TV device will be expecting an input signal from a source of video at the respec-
tive input socket in this setting. Please pay attention to the correct selection and set-
ting of the output of your source of video.
Note: The TV device is equipped with an automatic and complex function of recognising
the type and source of the signal. However, incorrect recognition can occur because of
the different tolerances of the source of your signal. Use the manual settings for the in-
put in this case.
4. Horizontal position:
You can change the horizontal position of the picture from the respective input socket
with the VOL+/VOL- buttons.
5. Width:
You can change the width of the picture from the respective input socket with the
VOL+/VOL- buttons.
6. Vertical position:
You can change the vertical position of the picture from the respective input socket with
the VOL+/VOL- buttons.
7. Pixel phase:
You can optimise the presentation of text on the TV device (e.g. in the case of shaking
letters) and compensate for possible faults in the picture (disturbance in the picture or
wavy lines) with the
8. Frequency:
Possible faults in the picture (disturbance in the picture or wavy lines) can be compen-
sated for with the
case of problems.
9. Audio input (only active in the PC HDMI mode, not in the PC VGA mode):
It is possible to choose between the DIGITAL/ANALOG settings with the
tons or through a list of choices, which can be reached by pressing the MENU button.
DIGITAL: Your TV device will reproduce the digital sound present in the HDMI signal.
ANALOG: The sound signal from the analogue Audio In socket will be reproduced.
Note: The digital HDMI signal usually consists of image and sound. However, it can defi-
nitely occur that your PC or your source of video does not transmit the sound information
by means of an HDMI signal or DVI signals are reproduced through a so-called DVI-HDMI
adapter. In this case, you will have to make the audio signal available through the ana-
logue HDMI Audio In socket of your TV device and switch the audio input to the ANALOG
setting.
10. You leave the Menu with the EXIT button.
Note: The device is provided with standardized pre-settings for the above setting values.
Nevertheless, manual adjustment of the settings values may be necessary, to achieve undis-
rupted reproduction and complete reproduction, because of deviating signals of your video
adapter or your video source!
30
VOL+/VOL- buttons.
VOL+/VOL- buttons. This setting should only be changed in the
E E
N N G G L L I I S S H H
VOL+/VOL- but-