Publicité
Les langues disponibles
Les langues disponibles
5 Install the bottom case.
Installation using a switch box
● Secure at least two corners of the switch box with screws.
Direct wall installation
● Thread the cable through the groove.
● Secure at least two corners of the remote controller with screws.
● Be sure to secure top-left and bottom-right corners of the remote controller (viewed from the front) to prevent it from lifting.
(Use molly anchor etc.)
Installation using a switch box
Double switch box
Roundhead cross
slot screws
Important
To avoid damage to the controller, do not overtighten the screws.
6 Cut out the cable access hole.
Direct wall installation (when running the cable along the wall)
● Cut out the thin-wall part on the cover (indicated with the shaded area in the right figure)
with a knife or a nipper.
● Thread the cable from the groove behind the bottom case through this access hole.
7 Route the wire to the top case.
Connect the connector on the bottom case to the connector on the top case.
Securely connect the
connectors.
Important
To prevent malfunctions, do not remove the protective film or the
circuit board from the casing.
Seal the cable access
hole with putty.
Refer to 2.
Remote controller
cable
Refer to 4.
To avoid damage to the controller, do not make holes on the controller
cover.
To prevent cable breakage and malfunctions, do not hang the top
controller casing by the cable.
- 6 -
Eng-6
Direct wall installation
Remote controller
cable
Wood
Refer to 4.
screw
Thread the cable
through the groove.
Publicité
