What To Do If - AEG HK634060XB Notice D'utilisation

– Stop the appliance and let it cool down before you clean: limescale rings, water
rings, fat stains, shiny metallic discolorations. Use a special cleaner for glass ceramic
or stainless steel.
2. Clean the appliance with a damp cloth and some detergent.
3. At the end rub the appliance dry with a clean cloth.

WHAT TO DO IF...

Problem
You cannot start the appliance
or operate it.
The residual heat indicator does
not come on.
The automatic heat up function
does not start.
A sound operates and appliance
starts and stops again. After 5
seconds one more sound oper-
ates.
comes on.
and a number come on.
If you tried the above solutions and cannot repair the problem, speak to your dealer or the
Customer Care Department. Give the data from the rating plate, three-digit-letter code for
the glass ceramic (it is in the corner of the cooking surface) and an error message that
comes on.
Possible cause and remedy
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• There is water or fat stains on the control panel. Clean the
control panel
• The key lock or child safety device operates
function. See the section "Locking/unlocking the control pan-
el" and "Child safety device".
• The STOP+GO function operates
the section "Starting the STOP+GO".
• Start the appliance again and set the heat setting in 10 sec-
onds.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone must be hot, speak to the after sales
service.
• There is still residual heat on the cooking zone
cooking zone cool down
• The highest heat setting is set. The highest heat setting has
the same power as the automatic heat up function.
• You set the heat setting with
and use only.
You covered . Uncover the sensor field.
• The automatic switch-off operates. Stop the appliance and
start it again.
Overheating protection for the cooking zone operates. Stop the
cooking zone and start it again.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If comes on again, speak to the after sales
service.
What to do if...
. Stop the
. Stop the function. See
. Let the
sensor field. Start from
47