golmar Stadio Plus T500SE ML Manuel D'installation page 65

TELEPHONES PROGRAMMING
P
rogramming the T-940 Plus telephones.
Set to ON the switch number 2 of the SW2 configuration dip switch, that's
accessible in the EL500SE module by opening the terminal connector
protection cover.
The door panel will reproduce a sound to advise that the system has
entered into programming mode.
In systems with more than one door panel, the programming process shall
be done on the master door panel only.
To program the telephone from a general door panel (if it exists), see page 116.
Switch off the telephone to be programmed.
Once the telephone is off, press the door release push button.
With the door release push button pressed switch on the
telephone.
To show that the system is ready for programming, the door
panel will reproduce a tone and the telephone led will blink.
At this moment, the door release push button can be
released. Lift the handset to establish audio communication
with the door panel.
Each apartment must have one master unit only; in case of parallel units configure them as
slaves, both monitors or telephones.
Make a call to check that the telephone has been succesfully programmed.
Repeat these steps to program the rest of telephones.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a tone to advise that the
system is still into programming mode.
127
Press the door panel push button that will call
to this telephone. At this moment the door
panel will reproduce a tone and the
telephone led will blink.
To program the telephone as master, switch it
off and on again.
To program it as slave, press the door release
push button.
To program it as slave with intercom function
press the center push button.
128
b
d
a
c
e
T
erminal connector description.
+, - :
A , D :
Al :
_ A D _ HZ
+ Al SA + Int PA HZ :
SA :
INT :
PA :
C
all volume control.
The telephone allows to regulate the call volume with a maximum,
medium and off value. With the help of the switch of three positions
placed in the right front of the telephone.
TELEPHONE DESCRIPTION
D
escription of the T-740 Plus telephone
a. Telephone handset .
b. Speaker grille .
c. Microphone hole .
d. Subjection hole .
e. Telephone cord connectors .
f. Door release push button .
f
g. Hook switch .
h
h. Auxiliary function push button .
i
i. Volume control .
g
e
Positive, ground.
Audio, digital communication.
Connection to external door release push button.
Door bell push button input.
Auxiliary calling device output SAV-90 .
Intercom.
Output for aux. relay activation (18Vdc/0,5A max.)
MAX
OFF
.