Function Push Buttons; Telephone Installation - golmar Stadio Plus T500SE ML Manuel D'installation

TELEPHONE DESCRIPTION
b
d
a
c
e
The telephone has a three positions switch placed on the bottom
part of the telephone (closest to the telephone cord connector)
that allows to control the call reception level volume.
a.
On-Off push button.
After any telephone reset, and during the next 45 seconds, all the
telephone functions will be disabled, with the exception of call
reception.
b.
This push button allows to make an intercom call when the handset
is not on the craddle. This function is described on page 147.
c. If the handset is on the craddle sends a panic call to the porter's
a
exchanges that have enabled the reception of this type of call. If
not, allows to call to the master porter's exchange. During call
b
reception and communication progresses allows the lock release
activation.
c
D
escription of the T-940 Plus telephone.
a. Telephone handset.
b. Speaker grille.
c. Microphone hole.
d. Subjection hole.
e. Telephone cord connectors.
f.

Function push buttons.

g. On-Off light indicator.
h. Call reception volume control.
i. Hook switch.
F
unction push buttons.
125 126
T
erminal connector description.
+ _
F
ix the telephone.
f
g
e
h
i
Pass the installation wires through the corresponding hole and
connect them as shown on the installation diagrams.
Close the telephone as shown on the picture. Once the telephone
is closed, connect the handset using the telephone cord and put
it on the craddle.
TELEPHONE DESCRIPTION
+ , – : positive, ground.
A , D : audio, digital communication.
INT : intercom.
A D INT SA HZ-
SA : auxiliary calling device output.
HZ- : door bell push button input.

TELEPHONE INSTALLATION

It will be necessary to open the telephone for wiring and
fixing purposes. To open the telephone insert a plain
screwdriver into the slots and rotate it as shown.
Avoid to place the telephone near to
heating sources, in dusty locations or
smoky environments.
The telephone can be fixed using an
electrical embedding box or directly on
the wall, as shown on the picture. If the
telephone will be installed directly over
the wall, drill two holes of Ø6mm. on the
specified positions, using 6mm.
wallplugs and Ø3,5 x 25mm. screws.