Conventions; General Precautions - Welch Allyn 88002 Manuel D'utilisation

Conventions

WARNING: Warnings alert the user to the possibility of serious injury, death, or other adverse reaction
associated with the use or misuse of the device.
CAUTION: Cautions indicate a potentially hazardous situation that, if not avoided, may result in minor
or moderate injury and/or damage to the equipment. They also alert against unsafe practices.
NOTE: Notes provide supplemental information to the text and indicate a potentially hazardous situation, which, if not
avoided, may result in property damage. They also highlight important information on the use of this equipment.

General Precautions

• For safety, the video colposcope should only be coupled to a grounded 110-120 VAC hospital-grade outlet (220 - 240
volt, 50 cycle international).
• The video colposcope should not be operated in the presence of flammable or explosive gases or chemicals, or installed
in areas where these materials are commonly used.
• To avoid overheating, the video colposcope should not be positioned closer than 6" to any wall.
• Keep all liquids away from electrical equipment to avoid the possibility of shock and instrument damage.
• Occasionally inspect the power cord for signs of cuts, abrasions or dents.
• The video colposcope should never be stored or operated in areas where it could get wet or could be exposed to any
environmental conditions like extreme temperature or humidity, direct sunlight, dust, etc.
• The lamp is extremely bright. DO NOT stare directly into illumination lens when the lamp is lit.
• All service to the video colposcope must be performed by Welch Allyn or by an authorized repair center.
• Video colposcope user should adhere to the operating conditions found in this manual. Otherwise, instrument damage
may occur and/or operator/patient safety may be compromised.
• There are no user servicable parts (other than the lamp and fuses) in this unit or in its accessories. Any attempt to
disassemble and/or repair this unit will result in voiding of the warranty.
2