Description - Inventum AKD6005ZWA Manuel D'utilisation

3

Description

INTENDED USE
The appliance is intended to be used for handling the air of cooking fumes.
Do not use the appliance for any other purpose than described in this document.
WALL-MOUNT COOKER HOOD
(Figure 1)
A Shaft
B Control panel
C Cooker hood
CONTROL PANEL
(Figure 2)
A Lamp button
B Speed button 1
C Speed button 2
Item
Lamp button
Speed button 1
Speed button 2
Speed button 3
Speed button 4
WORKING PRINCIPLE COOKER HOOD
(Figure 3)
The appliance is used for handling the air of cooking fumes.
The appliance can be installed in two different ways.
Extracting (A)
The cooking fumes are extracted outside.
Warning:
Never connect the pipe to a duct that contains gas or other fuels.
Recirculating (B)
The cooking fumes go through a carbon filter or a plasma filter. The filter purifies the fumes and recirculates these
back to the kitchen.
A good outflow of the air is necessary.
Extra information
• Note:
New houses may no longer vent outside.
• For recirculation, it is necessary to use carbon filters or a plasma filter. For more information on the differences
between carbon and plasma filters go to the website www.inventum.eu.
D Lights
E Grease filters
D Speed button 3
E Speed button 4
Function
To activate/deactivate the lamps.
• To start and stop the appliance at the lowest speed.
• To activate the automatic switch-off mode.
• To start and stop the appliance at the middle speed.
• To activate the automatic switch-off mode.
• To start and stop the appliance at the highest speed.
• To activate the automatic switch-off mode.
To activate the booster mode.
English • 29