Description - Inventum AKD9015GTZ Manuel D'utilisation

3

Description

INTENDED USE
The appliance is intended to be used for handling the air of cooking fumes.
Do not use the appliance for any other purpose than described in this document.
WALL-MOUNT COOKER HOOD
(Figure 1)
A Shaft
B Control panel
C Cooker hood
CONTROL PANEL
(Figure 2)
A Down button
B Up button
C Display
Item
Down button
Up button
Display
Timer button
Lamp button
WORKING PRINCIPLE COOKER HOOD
(Figure 3)
The appliance is used for handling the air of cooking fumes.
The appliance can be installed in two different ways.
Extracting (A)
The cooking fumes are extracted outside.
Warning:
Never connect the pipe to a duct that contains gas or other fuels.
Recirculating (B)
The cooking fumes go through a carbon filter or a plasma filter. The filter purifies the fumes and recirculates these
back to the kitchen.
A good outflow of the air is necessary.
Extra information
• Note:
New houses may no longer vent outside.
• For recirculation, it is necessary to use carbon filters or a plasma filter. For more information on the differences
between carbon and plasma filters go to the website www.inventum.eu.
30 • English
D Lights
E Grease filter
D Timer button
E Lamp button
Function
• To stop the appliance.
• To decrease the speed or set time.
• To start the appliance.
• To increase the speed or set time.
• To activate the refresh control function.
To show the set speed level and the set time.
• To delay stopping the appliance.
• To reset a saturation indicator.
To activate/deactivate the lamps.