Install The Blower Tube; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks 2400802 Manuel D'opérateur

10.2

INSTALL THE BLOWER TUBE

1. Align the grooves (4) on the rear tube (2) with tabs (5) on
the blower housing.
2. Install the rear tube onto the blower housing until the tabs
engage the grooves.
3. Turn the rear tube in the direction of the arrow until the
two tabs lock into the positions.
4
2
4. Align the hole (6) on the front tube with the tab (7) on the
rear tube.
5. Install the front tube onto the rear tube until the tab locks
into the position.
10.3

INSTALL THE BATTERY PACK

WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
5
7
6
English
10.4

REMOVE THE BATTERY PACK

1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
11

OPERATION

Make sure the blower tube is in position before operation.
11.1

START THE MACHINE

8
1. Pull the trigger (1) to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.
11.2

STOP THE MACHINE

1. Release the trigger to stop the machine.
Wait until the motor stops after you stop the machine.
11.3

CRUISE CONTROL LEVER

8
7
WARNING
1
NOTE
1
EN