Using The Blower - GreenWorks 12A BLOWER Manuel Du Propriétaire

OPERATION
USING THE TOOL AS A BLOWER
Converting to a Blower
1. Place the shoulder harness over the head and on the shoulder, and adjust it if necessary. Refer to
the section entitled
Attaching the shoulder strap.
2. Start the Blower/Vac.
3. Set the Blower/Vac mode flip-lever to the up position (Blower Mode) (Fig. 7).
NOTE: Do not use the Blower/Vac if the lever is halfway between the modes.

Using the Blower

Hold the blower as shown in Figures 8, 9, and 10. Sweep from side to side, with the nozzle
several inches above the ground or floor. Slowly advance the blower, keeping the accumulated
pile of debris in front. Most dry blowing operations are better suited to low speeds rather than
high speeds. High-speed blowing is better suited to moving heavier items, such as large debris or
gravel.
1. Use the blower for trees, shrubs, flower beds, and hard-to-clean areas (Fig. 8).
2. Use the blower around buildings and for other normal cleaning procedures (Fig. 9).
3. Use the blower around walls, overhangs, fences, and screens (Fig. 10).
Blower
Flip-Lever
Fig.7
Fig.8
Fig.9
Fig.10
16