Agu N3 Mode D'emploi page 47

• Do not use the device when a malfunction is detected until the device is repaired.
• Do not use the device in areas with presence of flammable gases, oxygen
or aerosol products.
• Do not use the device with empty medicine cup.
• Do not block the air openings. Do not place the device on a soft surface as
the air openings may be blocked.
• Unplug the device before cleaning, filling and after each use.
• Unplug the device when not in use.
• Do not turn down or shake the device during operation.
• Use only accessories recommended by the manufacturer.
• Do not touch the power switch with wet hands.
• Do not disassemble or attempt to repair the device yourself.
• Do not use this device for artificial lung ventilation and inhalation anaes-
thesia.
USAGE PRECAUTIONS
• This device is not intended for use by people (including children) with phys-
ical, neurological or mental disorders, or who have lack of experience and
knowledge, except when these persons are supervised or instructed on
the use of the device by the person responsible for their safety. It is neces-
sary to supervise children in order to prevent any improper use of with the
device, its accessories, as well as factory package.
• Avoid contact of medicines, vapours or aerosol with eyes.
• The maximum capacity of the medicine cup is 6 ml. Do not exceed this
amount.
• Do not use the device while driving.
• Unplug the device as soon as you feel discomfort or experience reduced
general condition during inhalation.
• Do not use the device if the air hose is curved.
STORAGE PRECAUTIONS
• Keep away from direct sunlight, high temperatures and humidity.
• Keep out of the reach of children.
• Unplug the device when not in use.
CLEANING PRECAUTIONS
• Check air filter, mouthpiece, nebulizer and other auxiliary components
before each use. Contaminated or worn out components must be replaced.
• Do not immerse the device in liquid to avoid its damage.
• Unplug the device before cleaning.
• Clean all necessary accessories after each use according to the instructions
in this manual.
EN
47