Black & Decker BDCMS20 Mode D'emploi page 8

INTENDED USE
Your BLACK+DECKER BDCMS20 sander
has been designed for sanding wood,
metal, plastics and painted surfaces. This
tool is intended for consumer use only.
OPERATING INSTRUCTIONS
WARNING:
To reduce the risk of
serious personal injury, read and follow all
important safety warnings and instructions
prior to using this tool.
INSTALLING AND REMOVING THE
BATTERY PACK FROM THE TOOL
CAUTION:
Make certain the switch is off prior
to installing or removing the battery pack.
TO INSTALL BATTERY PACK:
Insert battery pack (7) into tool until fully
seated and an audible click is heard
(figure A). Make sure battery pack is fully
seated and fully latched into position.
TO REMOVE BATTERY PACK: Depress
the battery release button in the back of
the battery pack and pull battery pack out
of tool (figure B).
A
B
OPERATION
NOTE: Do not rest fingers on platen during
use. Move the sander in long sweeping
strokes across the surface, letting the
tool do the work. Light pressure is all
that is required for sanding, polishing or
scrubbing. Excessive pressure will slow
the tool and produce inferior results. Check
your work often, product is capable of
removing material rapidly.
WARNING:
circumstances should this product be used
near water.
CAUTION:
injury, turn off and remove the battery from
the tool before making any adjustments or
removing or installing attachments or
accessories.
SWITCHING ON AND OFF
• To switch the tool "ON", depress the on/off
switch (1) at the forward position I.
• To switch the tool "OFF", depress the on/
off switch (1) at the back position O.
FITTING SANDING SHEET (FIG. C)
• Hold the tool with the sanding base facing
upwards.
• Place the sanding sheet (8) onto the
sanding base, making sure that the holes in
the sheet line up with the holes in the base.
FITTING SANDING TIPS (FIG. C)
• Detach the two additional diamond-shaped
tips (9) from the sanding sheet (8).
NOTE:
The diamond-shaped tip (10) can
be reversed and replaced when worn.
• When the front part of the tip (9) is worn,
detach it from the sheet, reverse it and
press it onto the sanding base again.
• When the whole tip is worn, remove it from
the sanding base and fit a new tip.
NOTE:
For optimal dust collection, ensure
the correct type of sanding paper is used.
9 9
C
8
Shock hazard. Under no
To reduce the risk of
8