Connecting Up; The Back Panel; Connecting The Am And Fm Antennas; Am Loop Antenna - Pioneer X-MT2000 Mode D'emploi

2 Connecting Up

SUB-WOOFER terminal.
See Using a sub-
woofer on page 11
SPEAKER terminals.
See Connecting the
speakers on page 10
AUX terminals. See
Connecting to other
components on page 11
8
En

The back panel

Before plugging in and switching on, you should connect the speakers and the two radio
antennas. Optionally you can connect a powered sub-woofer, and an external component,
such as an MD recorder.

Connecting the AM and FM antennas

Connecting the supplied antennas will allow you to listen to both AM and FM radio
broadcasts. If you find that reception quality is poor, an outdoor antenna should give you
better sound quality—see Connecting external antennas on the following page for more
on how to do this.
Important: Before making or changing antenna connections, make sure that the
power is switched off and the unit disconnected from the AC wall outlet.

AM loop antenna

1 Assemble the antenna as shown below.
ANTENNA terminals.
See Connecting the
AM and FM antennas
starting on this page.
Power cord. See
Plugging in to the mains
on page 11