External Fm Antenna; Connecting The Speakers - Pioneer X-MT2000 Mode D'emploi

2 Connecting Up
SPEAKERS
Red
Black
Speaker terminals on the rear panel
Black
Speaker terminals on the rear of
each speaker
10
En

External FM antenna

Connect an outdoor FM antenna as shown below.

Connecting the speakers

Red
When connecting or disconnecting speakers, make sure that the power is switched off and
the unit unplugged from the wall outlet.
To get the best sound from the system, it's important that the red (+) and black (–)
Black
speaker terminals on the rear of the unit are connected to the corresponding terminals on
each speaker. The wires and terminals are color-coded to make this easier.
Important: Make sure that the bare speaker wires cannot touch each other, or come
into contact with other metal parts once the unit is switched on.
1 Insert a wire into each speaker terminal on the rear of the unit.
Red
2 Insert the speaker wires into the terminals on the rear each
speaker.
To open a terminal, press down on the tab. Insert the wire then release the tab to secure it.
75Ω coaxial cable