Decommissioning; Switching Off The Appliance; Taking The Appliance Out Of Service; Disposal - V-ZUG Komfort 60i Mode D'emploi

The sound is normal.
u
A quiet clicking noise.
→ The noise is produced whenever the refrigeration unit
(motor) automatically switches on or off.
The sound is normal.
u
A hum. It is briefly a little louder when the refrigeration
unit (the motor) switches on.
→ Refrigeration increases automatically when the Fast-Freeze
function is activated, fresh food has just been placed in the
appliance or the door has been left open for a while.
This noise is normal.
u
→ The ambient temperature is too high.
Solution: (see 1.2 Appliance range of use)
u
A low hum.
→ The sound is produced by air flow noise of the fan.
The sound is normal.
u
Vibration noises
→ The appliance is not standing firmly on the floor. As a result
objects and adjacent units start to vibrate when the refriger-
ator is running.
u Check the installation and realign the appliance.
u Keep bottles and jars apart.
Flow sound at the soft stop mechanism.
→ The noise is produced when the door is opened and
closed.
The sound is normal.
u
The temperature display indicates:
→ There is a fault.
Please contact the after-sales service (see 6 Mainte-
u
nance) .
DEMO shines in the temperature display.
→ The demo mode is activated.
Please contact the after-sales service (see 6 Mainte-
u
nance) .
The outer surfaces of the appliance are warm*.
→ The heat of the refrigeration circuit is used to prevent
condensate from forming.
This is normal.
u
The temperature is not cold enough.
→ The door of the appliance is not properly closed.
Close the door of the appliance.
u
Insufficient ventilation.
→
Keep ventilation grille clear, and clean it.
u
→ The ambient temperature is too high.
Solution: (see 1.2 Appliance range of use) .
u
→ The appliance was opened too frequently or for too long.
Wait to see whether the appliance reaches the required
u
temperature by itself. If not, please contact the after sales
service (see 6 Maintenance) .
→ The temperature is incorrectly set.
Set the temperature to a colder setting and check after 24
u
hours.
→ The appliance is too close to a source of heat (stove, heater
etc).
Change the position of the appliance or the source of heat.
u
The appliance was not inserted properly into the recess.
→
Check whether the appliance was inserted correctly and
u
the door closes properly.
The internal light does not come on.*
→ The appliance is not switched on.
Switch the appliance on.
u
→ The door was open for longer than 15 minutes.
The internal light switches itself off automatically after about
u
15 minutes if the door is open.
→ The LED illumination is faulty or the cover is damaged:
* Depending on model and options
Risk of injury due to electric shock!
There are live electrical parts under the cover.
u Only ever have the inside LED light replaced or repaired by
Risk of injury from LED bulb!
The light intensity of the LED light corresponds to hazard group
RG 2.
If the cover is defective:
u Do not look directly into the light from close range. It cause
The door seal is defective or needs to be replaced for
another reason.
→
u
The unit has iced up or condensation has formed.
→
u

8 Decommissioning

to
F0 F9

8.1 Switching off the appliance

u Press On/Off button
w If the appliance cannot be switched off, the child lock func-

8.2 Taking the appliance out of service

u Empty the appliance.
u Switch off the appliance (see 8 Decommissioning) .
u Remove mains connector.
u Clean the appliance (see 6.2 Cleaning the appli-
u Leave the door open to prevent odour.

9 Disposal

9.1 Preparing appliance for disposal

Lamps
u Take the appliance out of operation. (see 8.2 Taking the
u Appliances with batteries: remove the batteries. For descrip-
u If possible: remove lamps without destroying them.
Decommissioning
WARNING
customer service or trained personnel.
WARNING
injury to the eyes.
The door seal can be replaced. It can be replaced without
the need for special tools.
Contact Customer Service (see 6 Maintenance) :
The door seal may have also slipped out of its groove.
Check to ensure that the door seal is seated properly in the
groove.
Fig. 2 (1) for approx. 2 seconds.
tion is active (see 5.1 Child proofing) .
ance) .
V-ZUG uses batteries in some of its appliances.
In the EU, for environmental reasons, legislation
obliges the end user to remove these batteries
before disposing of old appliances. If your appli-
ance contains batteries, a corresponding notice is
attached.
If you can remove the lamps yourself without
destroying them, also remove these before
disposal.
appliance out of service)
tion, see Maintenance chapter.
37