Electrical Connections - EKOM DK50 2V/50 Manuel De L'utilisateur

DK50 2V/50
DK50 2x2V/110
1

ELECTRICAL CONNECTIONS

The product is equipped with a grounded plug.
Ensure full compliance with all local electrical codes. The mains voltage and
frequency must comply with the data stated on the device's label.
 Keep the socket easily accessible to ensure that in an emergency the
device can be safely disconnected from the mains.
 Connection to the power distribution cabinet must be max.16 A.
 Connect the pin for equipotential bonding  6 mm (1) to the electrical
circuit using the defined method under valid electrical engineering
regulations. The socket for equipotential bonding (2) is an accessory
and is not provided in the basic package. (Fig. 10)
Ensure the electrical cable does not touch hot compressor components. Risk of
electric shock!
If any electrical cord or air hose is damaged it must be replaced immediately.
Attach the earthing conductor to the door and screw it into the cabinet.
Power supply feed:
Connecting a compressor not installed in a cabinet
 Insert the mains plug into a rated mains socket.
 The compressor is ready for operation.
12/2021
230V/50(60)Hz
400V/50(60)Hz
-33-
1
3Gx1.5x4000
5Gx1.5x4000
NP-DK50 2V 50, 2x2V 110-27_12-2021-MD
Fig.9
Fig. 10