General Power Tool Safety Warnings - Bosch GCM18V-12GDC Consignes D'utilisation/De Sécurité

1609B06757.qxp_GCM18V-12GDC 3/25/20 12:35 PM Page 3
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
1. Work area safety
a. Keep work area clean and well lit.
b. Do not operate power tools in explosive at-
mospheres, such as in the presence of flam-
mable liquids, gases or dust.
c. Keep children and bystanders away while
operating a power tool.
2. Electrical safety
a. Power tool plugs must match the outlet.
Never modify the plug in any way. Do not
use any adapter plugs with earthed
(grounded) power tools.
b. Avoid body contact with earthed or
grounded surfaces, such as pipes, radia-
tors, ranges and refrigerators.
c. Do not expose power tools to rain or wet
conditions.
d. Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the
power tool. Keep cord away from heat, oil,
sharp edges or moving parts.
e. When operating a power tool outdoors, use
an extension cord suitable for outdoor use.
f. If operating a power tool in a damp location
is unavoidable, use a Ground Fault Circuit
Interrupter (GFCI) protected supply.

General Power Tool Safety Warnings

Read all safety warnings instructions, illustrations and specifications pro-
vided with this power tool.
SAVE THESE INSTRUCTIONS
3. Personal safety
a. Stay alert, watch what you are doing and
use common sense when operating a power
tool. Do not use a power tool while you are
tired or under the influence of drugs, alco-
hol or medication.
b. Use personal protective equipment. Always
wear eye protection.
c. Prevent unintentional starting. Ensure the
switch is in the off-position before connect-
ing to power source and / or battery pack,
picking up or carrying the tool.
d. Remove any adjusting key or wrench before
turning the power tool on.
e. Do not overreach. Keep proper footing and
balance at all times.
f. Dress properly. Do not wear loose clothing
or jewelry. Keep your hair, clothing and
gloves away from moving parts.
g. If devices are provided for the connection
of dust extraction and collection facilities,
ensure these are connected and properly
used.
h. Do not let familiarity gained from frequent
use of tools allow you to become compla-
cent and ignore tool safety principles.
3