Operating The Revolving Console; Initial Operation - HASE Bari Manuel D'utilisation

5 . Operating the Revolving Console

The Bari has a maximum rotational angle of 180 de-
grees; you can adjust the rotational angle in 15-de-
gree increments.
Unlock the rotary console by briefl y pressing the
button A and then turn the Bari to the desired po-
sition. Shortly before the fi nal position is reached,
press the key A again and lock the stove into place
with a slight rotational movement.
fi g. 3
WARNING!
Never turn stove when lighting fi re!
In the whole rotational area range, the safe
distances (radiation area) apply to distanc-
es to fl ammable materials.
34
2. Vorbereitung zur Montage
2.5 Drehwinkel am Aufstellort einstellen
fi g. 4
A
fi g. 5

6 . Initial Operation

NOTE!
During shipment, condensation moisture
can accumulate in the stove's interior,
which may possibly lead to the appearance
of condensation or water on the stove or
fl uepipes. Please dry off these damp areas
immediately.
The surface of your stove was treated in a sand-
blasting machine before applying the colour coating.
Despite careful and thorough inspection, there may
still be some residual material in the stove body,
which can fall out when your stove is being installed.
NOTE!
To prevent any damage, please immedi-
ately vacuum up these small steel pellets
with a vacuum cleaner.
The fi rst time a stove is operated, the heat develop-
ment causes the emission of volatile components
from the coating, sealing strips and lubricants, and
smoke and odours can occur.
At a higher combustion temperature, this one-time
process can take between 4 to 5 hours.
To achieve this higher combustion temperature,
please increase the fuel quantity recommended in
Section 8, „Adding Fuel/ Heating with Nominal Ther-
mal Output", by approximately 25%.
CAUTION!
To prevent adverse effects on health, no-
body should stay in the room(s) during