Ottobock 17B59 Serie Instructions D'utilisation page 14

► The product may only be installed by trained, qualified personnel.
► Observe the alignment and assembly instructions.
INFORMATION
Parallel alignment of the orthotic joints
Use the 743R6 alignment fixture to position the orthotic joints on the plaster
positive.
Mounting the foot stirrup
Prerequisite: The orthotic ankle joints are disassembled. To do so,
>
remove the joint screw and the bearing nut from the joint.
1) Insert the contoured foot stirrup into the orthotic ankle joint.
2) Assemble the foot stirrup and the orthotic joint with the bearing nut and
the joint screw.
3) For final assembly, secure the screw connection with Loctite 241.
Improving corrosion protection
Polish or sinter the product for improved corrosion protection. Ottobock
recommends the 618T40* sintering powder for surface coating.
► Do not heat the material longer than 5 minutes at max. 150 °C for sur­
face coating.
Gluing in bars
Required materials: 636W28* special adhesive, degreasing cleaner
The bars must be glued in the insertion zones to ensure stability.
1) Clean the connecting surfaces with a degreasing cleaner.
2) Apply the special adhesive to the connecting surfaces.
3) Insert the bars.
4) Secure with the enclosed screws.
5) Allow to cure for at least 4 hours.
INFORMATION: Final bonding strength will be reached after
16 hours.
Using protective devices
► Use joint protectors to protect the product against soiling.
6 Cleaning
Promptly clean the product after contact with:
• Water containing salt, chlorine or soap, perspiration, urine or splashed
water (e.g. after rain) and soiling.
1) Rinse the product with clear fresh water.
14