To Drive / Transport; Hillside Operation - Textron Jacobsen Tri-King Triplex Manuel De L'opérateur Et De Sécurité

5.6

TO DRIVE / TRANSPORT ____________________________________________________

Read and follow all safety notes contained in this manual
when driving or transporting tractor. Refer to Section 5.3
for general operating instructions. When operating in
reverse look behind you to ensure you have a clear path.
Important: If this tractor is driven on public roads, it must
comply with federal, state and local ordinances. Contact
local authorities for
requirements.
The tractor is equipped with a transport lock to lock the
reels in their upright position. Use the transport locks
where required for transporting machine over rough
terrain, on public roads or on trailers.
To raise mowers to their transport position:
Set reel/3WD switch to OFF. Depress and hold the lift
pedal until the mowers are in their fully raised (transport)
position.
To engage transport locks:
1. Raise reels to their transport position.
2. Disengage all drives, engage parking brake and
stop engine.
5.7

HILLSIDE OPERATION _____________________________________________________

!
WARNING
To minimize the possibility of overturning, the safest
method for operating on hills and terraces is to travel
up and down the face of the slope (vertically), not
across the face (horizontally). Avoid unnecessary
turns, travel at reduced speeds, stay alert for hidden
hazards, and drop offs.
CAUTION:
Do not operate this tractor on
!
slopes greater than 16.2 °.
The tractor has been designed for good traction and
stability under normal mowing conditions; however, use
caution when operating on slopes, especially over rough
terrain or when the grass is wet. Wet grass reduces
traction and steering control.
1. Always mow with the engine at full throttle but reduce
forward speed to maintain the proper cutting fre-
quency.
regulations and equipment
!
3. Remove pin (A) and slide handle (B) from the top
slot (C-Storage Position) to the bottom slot (D-
Transport Position). Insert pin (A) to lock handle (B)
in place.
The operator has the option to transport in either 2-wheel
drive (2-WD) or 3-wheel drive (3-WD).
Note: Engage locks when storing machine overnight. To
prevent damage to the tractor, the transport lock must be
disengaged before reels can be lowered for cutting.
B
A
C
2. If the tractor tends to slide or the tires begin to
"mark" the turf, angle tractor into a less steep grade
until traction is regained or tire marking stops.
3. If tractor continues to slide or mark the turf, the
grade is too steep for safe operation. Do not make
another attempt to climb, back down slowly.
4. When descending a steep slope, always lower
implements to the ground to reduce the risk of
tractor overturning.
Correct tire pressure is essential for maximum traction.
OPERATION
A
B
D
Figure 5B
GB-13
5
C