Yamaha RX-V1065 Mode D'emploi page 67

Error message
E-7:NO MIC The optimizer microphone was
unplugged during the "Auto Setup"
procedure.
E-8:NO SIGNAL
The optimizer microphone does not
detect test tones.
E-9:USER CANCEL "Auto Setup" was canceled due to an
inappropriate user operation.
E-10:INTERNAL An internal error occurred.
ERROR
After Auto Setup
Error message
W-1:OUT OF PHASE Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
W-2:OVER 24m (80ft) The distance between the speaker and the
listening position is over 24 m (80 ft).
W-3:LEVEL ERROR The difference of volume level among
speakers is excessive.
W-4:CHECK PRNS Presence speakers were not detected
during measurement with "Extra Speaker
Assignment" set to "Presence".
Cause
Do not touch the optimizer microphone during "Auto
Setup".
Check whether the microphone is properly placed.
Check whether the speakers are properly placed and
connected.
The optimizer microphone or OPTIMIZER MIC
jack may be defective. Contact the nearest Yamaha
dealer or service center.
Run "Auto Setup" again.
Run "Auto Setup" again.
Cause
Check the polarities (+, –) of the displayed speaker.
If they are correct, the speakers work properly even
when this message is displayed.
Bring the speaker within 24 m (80 ft.) area around
the listening position.
Recheck the speaker positions and make sure all
speakers are placed in a similar environment.
Check the polarities (+, –) of the speakers.
We recommended that you use speakers with the
same or similar specifications.
Adjust the output volume of the subwoofer.
Check the presence speaker connections and perform
measurement again. If presence speakers are not
connected, set the "Extra Speaker Assignment" to
other than "Presence".
Troubleshooting
Remedy
Remedy
See
page
20
20
10, 11
—
20
20
See
page
12
—
—
12
—
—
11, 46
63
En