Yamaha RX-V1065 Mode D'emploi page 59

3
Enter the desired remote control ID code.
To switch to ID1:
Press lNumeric keys to enter "5019".
To switch to ID2:
Press lNumeric keys to enter "5020".
Once the remote control code is registered,
nTRANSMIT blinks twice.
If it fails, nTRANSMIT blinks six times. Repeat
from step 1.
y
• If you initialize the settings of this unit, "REMOTE ID" (remote control
code of this unit) is set to "ID1".
Advanced setup
55
En