Delay Time And Speaker Output Levels - Yamaha DSP-E800 Mode D'emploi

TEST EFFECT
DSP
TIME/LEVEL SET MENU
When using the digital sound field processor with the Dolby
Pro Logic decoder, Dolby Digital decoder or DTS decoder,
you can adjust the delay time between the main sound and
sound effect, and each speaker's output level as you wish.
Note
• When high-rate 96-kHz sampling 24-bit digital signals are input
to this unit, the delay time and speaker output levels cannot be
adjusted.
Delay Time
You can adjust the time difference between the beginning of
the sound from the main speakers and the beginning of the
sound effect from the rear speakers. The larger the value,
the later the sound effect is generated. The delay time can be
individually adjusted to all DSP programs.
Notes
• Adding too much delay will cause an unnatural effect with some
sources.
• The sound is momentarily interrupted while adjusting the delay
time.
Program
1. PRO LOGIC/Normal
DOLBY DIGITAL/Normal
DTS DGTL SUR/Normal
PRO LOGIC/ENHANCED
DOLBY DIGITAL/ENHANCED
DTS DGTL SUR/ENHANCED
2. 70 mm SPECTACLE
DGTL SPECTACLE
DTS SPECTACLE
70 mm SCI-FI
DGTL SCI-FI
DTS SCI-FI
3. 70 mm ADVENTURE
DGTL ADVENTURE
DTS ADVENTURE
70 mm GENERAL
DGTL GENERAL
DTS GENERAL
4. MONO MOVIE
5. TV SPORTS
6. DISCO
7. ROCK CONCERT
8. CONCERT HALL

DELAY TIME AND SPEAKER OUTPUT LEVELS

Preset
Control
value
range (ms)
15 to 30 20
0 to 15 5
0 to 15 5
15 to 30 20
0 to 15 5
0 to 15 5
15 to 30 23
1 to 99 15
1 to 99 15
15 to 30 20
1 to 99 16
1 to 99 16
15 to 30 20
1 to 99 15
1 to 99 15
15 to 30 20
1 to 99 15
1 to 99 15
1 to 99 49
1 to 99 9
1 to 99 40
1 to 99 16
1 to 99 44
Sound Output Level of the Center,
Right Rear and Left Rear Speakers,
and Subwoofer
If desired, you can adjust the sound output level of each
speaker even if it has already been adjusted in
"ADJUSTING THE SPEAKER BALANCE" on pages 14
and 15.
Notes
• The sound output level of the center speaker cannot be adjusted
when the input signal is analog, PCM audio, or encoded with
Dolby Digital in 2-channel.
• If "CENTER SP" on the SET MENU is set to the NONE position,
the sound output level of the center speaker cannot be adjusted.
This is because the center channel sound is automatically output
from the right and left main speakers.
• Once the sound output level has been adjusted, the level will be
the same for all DSP programs.
Speaker Control range (dB)
Center MIN, –20 to +10
Right rear MIN, –20 to +10
Left rear MIN, –20 to +10
Subwoofer MIN, –20 to 0
Preset value
0
0
0
0
E-29