Mantis Back Porch ComposTumbler CT08002 Guide D'assemblage page 4

STEP 2 – DOOR PANEL ASSEMBLY
WHAT YOU'LL NEED
Tools: Phillips screwdriver
Hardware: 2a - Handle
2b - Latch strike
2c - Socket bolts
2d - Screws #10
2e - Screws 5/8" (16mm)
2f - Lockwashers
Parts: Item 2 - (1) Door panel (with 4 holes—2 large,
2.1a
From the inside of the door panel, push the socket bolts
(2c) through the larger holes in the door panel.
2.2a
Start from driving the screws through from the inside of
the door panel, stopping just as the threads appear on the
outside.
Fasten the handle (2a) to the door panel with the two 5/8"
screws (2e). Use Phillips head screwdriver.
4
2 small—at one edge)
2
2.1b
From the outside of the door panel, position the latch strike
(2b) over the holes and fasten with the lockwashers (2f)
and #10 screws (2d) as shown. Use the Phillips screwdriver
to tighten the screws.
2.2b
Then position the handle over the screws and
drive them the rest of the way. Be careful not
to overtighten the screws, or you may risk
cracking the handle.
2
2a
2b
2d
2f
2e
2c