Connecting Antennas; Connecting The Am Loop Antenna; Connecting The Fm Antenna - Yamaha MCR-E410 Mode D'emploi

CONNECTING ANTENNAS

To enjoy radio on the receiver, connect the supplied AM and FM antennas to the designated terminals. If there is a
problem of weak radio wave reception in your area or you want to improve radio reception, we recommend that you use
optional outdoor antennas. For details, consult the nearest authorized YAMAHA dealer or service center.
AM loop
antenna
(supplied)
ANTENNA
75
UNBAL.
DOCK
CD FM
GND
IN
TAPE/MD
OUT
AM
AUX
R L
About grounding
For maximum safety and minimum interference, connect
the antenna GND terminal to a good earth ground. A good
earth ground is a metal stake driven into moist earth.

Connecting the AM loop antenna

1
Attach the antenna stand to the antenna.
When attaching the antenna to the wall, you do not
need to use the antenna stand.
2
Press down the tab of the AM terminal.
Note
Depending on the product, the shape of the tab is different from
the described illust.
14
En
Connecting Antennas
Indoor FM
antenna
(supplied)
SPEAKERS
6 MIN / SPEAKER
R L
Ground
(GND terminal)
3
Insert the AM loop antenna lead wires into
the AM terminal.
4
Replace the tab back to secure the wire.
5
Repeat steps 2 to 4 to insert the AM loop
antenna lead wires into the GND terminal.
6
Place the antenna away from the receiver and
speaker cables.
While listening to the radio, rotate the antenna head
to find the best angle for reception.

Connecting the FM antenna

1
Connect the supplied indoor FM antenna to
the FM jack of the receiver.
2
Place the antenna away from the receiver and
speaker cables.