RCF RDNET CONTROL 2 Manuel De L'utilisateur page 10

The RDNET software is protected by international copyright laws and is
to be used to configure the RCF RDNET system only.
lt is not allowed to modify or change or try to decompile this software.
In no event shall RCF be liable to end-users for any damage whatsoever,
including but not limited to financial damages for loss of business profits
or business information due to the software use or inability to use this
product. The foregoing provision is effective even if RCF has been
advised of the possibility of such damages. Even if the software has any
material, verifiable and reproducible program errors, RCF shall have no
obligation to modify such errors.
Minimum requirement: a PC with Microsoft Windows® XP,
Vista or 7 operating system, having an available USB port.
Before installing a new software release, it is necessary to remove
the previous version (if installed) by running Start > Programs > RCF
Group > RDNet > Uninstall and disconnect the USB cable between the
computer and the RDNET CONTROL 2 unit.
Run setup.exe (inside the 'setup folder)
to start the software installation.
If the installed PC software does not include the
release 4.0 of MS ".NET Framework" (necessary
to install the RDNET software), it will be show the
request for downloading from the web (for free).
If internet is available, click the YES button to open
the web page where it is possible to download the
last release of ".NET Framework" software, then
install it.
If ".NET Framework 4.0" has been previously
installed, the RDNET ware wizard starts.
Click the NEXT> button to proceed.
10
NOTES ABOUT THE
RDNET SOFTWARE
RDNET SOFTWARE
INSTALLATION