Meat Thermometer; Temperature Probe; Oven Vent - KitchenAid ARCHITECT II Serie Guide D'utilisation Et D'entretien

BAKEWARE/ RECOMMENDATIONS
RESULTS
Insulated cookie
sheets or baking
pans
Little or no bottom
browning
Stainless steel
Light, golden
crusts
Uneven browning
Stoneware/Baking
stone
Crisp crusts
Ovenproof
glassware, ceramic
glass or ceramic
Brown, crisp
crusts

Meat Thermometer

On models without a temperature probe, use a meat
thermometer to determine whether meat, poultry and fish are
cooked to the desired degree of doneness. The internal
temperature, not appearance, should be used to determine
doneness. A meat thermometer is not supplied with this
appliance. Follow manufacturer's directions for using a meat
thermometer.

Temperature Probe

(on convection models)
WARNING
Burn Hazard
Use an oven mitt to remove temperature probe.
Do not touch broil element.
Failure to follow these instructions can result in burns.
The temperature probe accurately measures the internal
temperature of meat, poultry and casseroles with liquid and
should be used in determining the doneness of meat and poultry.
It should not be used during full and center broiling, convection
broiling, dehydrating or proofing bread.
Always unplug and remove the temperature probe from the oven
when removing food.
To Use:
Before using, insert the probe into the center of the thickest
portion of meat or into the inner thigh or breast of poultry, away
from fat or bone at an angle as shown in following diagram. Place
food in oven and connect the temperature probe to the jack.
Place in the bottom third of oven.
May need to increase baking time.
May need to increase baking time.
Follow manufacturer's instructions.
May need to reduce baking
temperatures slightly.
Keep probe as far away from heat source as possible. Close oven
door.
A
A. Temperature probe jack
B. Temperature probe
1. Press the number pads to enter a probe temperature. The
probe temperature can be set between 130°F and 190°F
(54°C and 88°C).
2. Press BAKE, CONVECT BAKE or CONVECT ROAST.
Press number pads to enter a temperature other than the one
displayed.
3. Press START.
The set oven temperature will appear on the oven display
throughout cooking.
"Lo" will appear as the probe temperature until the internal
temperature of the food reaches 130°F (54°C) or if the probe
is unplugged. Then the display will show the temperature
increasing in 1°F increments.
When the set probe temperature is reached, the oven will
shut off automatically and "Cooking Complete" will appear on
the oven display.
If enabled, end-of-cycle tones will sound.
4. Press OFF or open the oven door to clear the display.
To Change Probe Temperature, Oven Setting:
Press OFF, then repeat previous steps.
After cooking, unplug the probe and remove food from oven. The
probe symbol will remain lit until the probe is unplugged from the
probe jack.
See "General Cleaning" section to clean probe.

Oven Vent

A
A. Oven vent cap
The oven vent should not be blocked or covered since it allows
the release of hot air and moisture from the oven. Blocking or
covering the oven vent will cause poor air circulation, affecting
cooking and cleaning results. Do not set plastics, paper or other
items that could melt or burn near the oven vent.
B
15