Quick Menu - Onkyo TX-NR474 Mode D'emploi

> Before Start > Part Names

Quick Menu

1
66
> Install > Initial Setup > Playback
Advanced Setup
By pressing the Q button on the remote controller during play, you can adjust frequently
used settings, such as the sound quality, using on-screen menus.
1. Press Q on the remote controller to display the Quick Menu.
Quick Menu
Tone Bass
Level Treble
AccuEQ
Other
2. Select the item with  /  on the remote controller and press ENTER to confirm your
selection.
0 Change the initial values for each of the settings with the cursors  / .
0 To return to the previous screen, press
3. To exit the settings, press Q.
∫ Tone
Bass: Enhance or moderate the bass range of the front speakers.
Treble: Enhance or moderate the treble range of the front speakers.
0 It cannot be set if the listening mode is Pure Audio or Direct.
∫ Level
Center: Adjust the speaker level of the center speaker while listening to some sound.
Subwoofer: Adjust the speaker level of the subwoofer while listening to some sound.
0 The adjustment you made will be reset to the previous status when you turn the unit to
standby mode.
∫ AccuEQ
AccuEQ Room Calibration: Enable or disable the equalizer function that corrects for
distortion caused by the acoustic environment of the room. If this is to be enabled, then
normally you should select "On (All Ch)", and to disable just the front speakers you should
select "On (ex. L/R)". The setting can be separately set to each input selector.
0 This setting cannot be selected if AccuEQ Room Calibration has not been performed.
Equalizer: Select "Preset 1" to "Preset 3" configured in "2. Speaker" - "Equalizer Settings"
| Supplementary Information | Others
BD/DVD
.