Initial Setup With Auto Start-Up Wizard - Onkyo TX-NR474 Mode D'emploi

> Before Start > Part Names

Initial Setup with Auto Start-up Wizard

Initial Setup
1
INPUT
2
20
> Install
3
> Initial Setup > Playback
Advanced Setup | Supplementary Information | Others
Initial Setup starts automatically
When you turn the unit on for the first time after purchasing
it, Initial Setup is automatically shown on the TV to enable
you to make settings required for startup using simple
operations following onscreen guidance.
1. Switch the input on the TV to that assigned to the unit.
2. Put batteries into the remote controller of this unit.
3. Press Í on the remote controller to turn the unit on.
4. Select the item with the cursors of the remote controller
and press ENTER (a) to confirm your selection. To return
to the previous screen, press (b).
a
0 If you terminate the procedure on the way or want to
change a setting made during Initial Setup, press
the remote controller, and select "6. Miscellaneous" -
"Initial Setup" and press ENTER. To select the language
displayed again, change "OSD Language" (P52).
∫ 1. AccuEQ Room Calibration
Place the supplied speaker setup microphone in the
listening position, measure the test tones emitted by the
speakers, then the unit automatically sets the optimum
volume level for each speaker, the crossover frequencies,
and the distance from the listening position. This also
automatically adjusts the equalizers for the speakers and
enables correction of distortion caused by the acoustic
environment of the room.
b
on