Norton Clipper CP512-300 Instructions D'emploi page 26

Starting up and switching off the engine
6.1 Starting process
Starting preparations
• Put the power tool level and free from obstacles on the flat floor and observe that the cut-off wheel does
not touch any objects.
• Put the wheel guard into the best position for the planned use.  Chap. 5.4, page 18
Automatic mixture control for cold and warm start
The power tool has an electronically controlled carburetor. Therefore, no special settings are required for
cold or warm start (e.g. manual operation of a choke).
Starting notes
• Turn the stop dial to the operating position "1".
• Before the first start, operate the primer. Chap. 4.5, page 14
• Before starting-up, push the decompression valve.  Chap. 4.5, page 14
• Put the power tool in start-up position.  Chap. 6.2, page 25
• Pull on the starter handle.  Chap. 6.3, page 25
ENGLISH 24
6 Starting up and switching off the engine
Observe safety provisions!