Adjusting The Wheel Guard; Fueling Up - Norton Clipper CP512-300 Instructions D'emploi

Preparing for use
5.4

Adjusting the wheel guard

If the separating device has been installed in the outer position, ensure when adjusting the wheel
guard that the water supply line is not clamped and that contact between the cut-off wheel and
water supply line in operation is excluded.
5.5

Fueling up

Danger to health!
Direct skin contact with gasoline and breathing in of gasoline fumes must be excluded.
The high-performance two-stroke engine of this power tool requires an oil-gasoline mix in the combustion
chamber (oil and gasoline = fuel mix).
Models CP512-300 and CP514-350
Store the fuel mix no longer than 3 weeks.
ENGLISH 18
The wheel guard (2) can be rotated forward and
3
backward in a limited area.
For adjustment of the wheel guard, the power tool
2
must be put securely on the ground. Securely hold
the power tool at the top handle (4) with the left
hand and push it firmly onto the ground. With the
right hand at the handle for wheel guard
adjustment (3), rotate the wheel guard accordingly.
To keep sparks and particles away from the user,
the wheel guard always must be rotated forward as
far as the working situation permits.
4
Models CP512-300 and CP514-350 are equipped
with a fuel tank (18).
18
The fuel mix must be formed from the following
components:
• Lead-free regular gasoline or lead-free super
gasoline (pump octane number PON ≥ 89
• Branded 2-stroke engine oil corresponding to the
standard ISO-L-EGD or JASO FD
Fuel tank for fuel mix according to the mix
table below.
Unsuitable fuels or deviations of the mix ratio
may cause engine damage!
(R+M) / )
2