ZUCCHETTI Lizard M Serie Manuel D'utilisation page 114

GB
Problem Causes
On the display
The robot receiver does
"Sync Error" appe-
not recognise the signal
ars
Damaged cutting blade
Cutting blade flooded by
residues (tapes, ropes,
plastic fragments, etc.)
The start of the robot oc-
On the display "Tall curred with obstacles
grass" appears being too close (less than
m away) or in presence
of unexpected obstacles
(fallen branches, forgot-
ten objects, etc.).
Electrical motor malfunc-
tion
Grass too high
Wrong programming
The telecommand
does not function
The led on the telecom-
mand does not come on
After installation of
the robot, distur-
bances are noti-
ced relative to Interference with other
domestic applian- electrical devices
ces (radio, televi-
sion, electric gates
etc.).
Solutions
Switch off the equipment and
switch it on again.
If the problem persists, con-
tact the assistance service
Replace the blade with a new
one (see "Replace the blade")
Stop the robot in safety condi-
tions (see "Robot safety stop")
Use protection gloves to
avoid the risk of cuts on
hands.
Remove the flood cause from
the blade.
Stop the robot in safety condi-
tions (see "Robot safety stop")
Remove the obstacles and re-
start the robot (see "Manual
startup and stop of robot (in
closed areas)")
Get the motor repaired or re-
placed by the nearest authori-
zed Assistance centre.
Increase the cutting height
(see "Adjusting the cutting
height").
Carry out preliminary cutting
of the area with a normal lawn
mower.
Correctly programme the te-
lecommand (see "Program-
ming mode")
Remove the battery and fit
the replacement (see "Tele-
command batteries replace-
ment the blade")
Contact an Assistance Cen-
tre authorized by the Manu-
facturer
- 54 -
Caution
User's manual