Operating Other Manufacturers' Equipment; Changing The Preset Signal Codes - JVC RX-DV31SL Manuel D'instructions

Operating Other Manufacturers' Equipment

The remote control supplied with this unit can transmit control signals for other manufacturers' TVs, DBS tuners, and VCRs.
By changing the transmittable signals from preset ones to the other manufacturers' signals, you can operate other
manufacturers' components using this remote control.

Changing the Preset Signal Codes

To operate other manufacturers' components using this
remote control:
• Aim the remote control directly at the remote sensor on
each equipment.
• To operate a source with the remote control, the source
must be selected using source selecting buttons on the
remote control.
• Refer also to the manuals supplied with your equipment.
To change the transmittable signals for
operating other manufacturers' TV
1
Press and hold TV
2
Press TV.
3
Enter the manufacturer's code using the
number buttons (1 – 9, 0).
See the table on the right to find the code.
4
Release TV .
You can always perform the following operations:
TV Turns on or off the TV.
TV VOL +/– Adjusts the volume.
TV/VIDEO Sets the input mode (either TV or
VIDEO).
After pressing TV, you can perform the following
operations on a TV:
CHANNEL +/– Changes the channels.
1 – 9, 0, 100+ Selects the channels.
For channel number 5, press 5.
For channel number 10, press 1, then 0.
For channel number 23, press 2, then 3.
For channel number 135, press 100+, 3,
then 5.
• TV RETURN will function as the
ENTER button if your equipment
requires pressing ENTER after
selecting a channel number.
Notes:
• Refer also to the manual supplied for your TV.
• Not all of the functions listed on the left may be assigned to
specific buttons for some TVs.
• If you cannot change the channels of some TVs by pressing the
number buttons, press CHANNEL + or – for changing the
channels.
65
.
5
Try to operate your TV by pressing TV
When your TV turns on or off, you have entered the correct
code.
If there is more than one code listed for your brand of
TV, try each one until the correct one is entered.
Manufactures' codes for TV
Manufacturer
JVC
Akai
Bell & Howell
Centurion
Coronad
Daewoo
Emerson
Fisher
GE
Goldstar
Hitachi
KTV
Magnavox
Marantz
Mitsubishi
Panasonic
Philips
Pioneer
Proscan
Quasar
RadioShack
RCA
Samsung
Sanyo
Sears
Sharp
Sony
Symphonic
Toshiba
Zenith
* "01" is the initial code.
Note:
• Manufacturers' codes are subject to change without notice.
If they are changed, this remote control cannot operate the
equipment.
.
Codes
01*
02
03
04
05
06 – 08
09 – 13
14
15, 16, 17
18, 19
20, 21
22, 23
24
25
25
26, 27
24
28
29
30
31
02, 17, 32 – 35
36, 37
14
38
39
40
41, 42
38
43, 44