Installation - Dalla Corte supermini Notice Pour L'utilisateur

installation

Place the machine on a surface that guarantees a secure support.
To get ready for set up , make sure you have an opening ( A-pic.1) on the support surface to allow
connection with systems in the space below ( B-pic.1).
The machine should be exclusively connected to a source of cold drinking-water.
The water pressure should be between 1 and 5 bar. If this is not possibile, please contact the manu-
facturer.
An interception tap must be installed between the water system and the water feed pipe of the
machine so that the passage of water can be closed if necessary (1-pic 1).
- Water tap
1
- Flexible water hoses
2
- Water softener (optional)
3
- Drain hose
4
- Drain siphon
5
- Electrical supply cable
6
- ON / OFF switch
7
A - Opening on the support plan
B - Space under the support plan
ATTENTION
The installation must be done following current regulation and according to the following instructions. A wrong installation can
cause damage to animals, objects or people. The manufacturer will not be held responsible for damages caused by improper
installation.
After removing the packing, check that the machine is in a perfect condition, in case of doubts do
not use it. The packing components must be kept out of the reach and sight of children because
they might be dangerous.
Place the machine on a secure support and arrange the foot so that the machine is in the correct position.
Before connecting the machine to the systems make sure that the data on the plate correspond to
those of the installation place.
1
3
A
2 4 6
5
Pic 1
B
7