Status Indicator Light And Sounds - ECOVACS ROBOTICS WINBOT X Manuel D'instructions

5. Status Indicator Light and Sounds

WINBOT emits beeps when encountering problems. When you hear the beeps, please check the Status Indicator Light list below to find the
solutions.
Indicator
WINBOT Status
Indicator Light
WINBOT
Safety Pod Status
Indicator Light
Battery Indicator
Safety Pod
Light
24
EN
Status
1. WINBOT is charging.
Flashing BLUE 2. WINBOT has been paired with the Safety Pod already and is ready to
be placed on the glass.
1. WINBOT has successfully adhered itself to the glass and is ready to
Continuous BLUE clean.
2. The Safety Pod is in preparation.
Flashing RED The robot's battery is low. Charge WINBOT as described in Section 3.2.
Continuous RED Please refer to Section 6. Troubleshooting for details.
The Safety Pod is not prepared to be pressed onto the glass:
1.The Safety Pod Jack is not inserted into WINBOT.
Flashing GREEN 2.The Safety Pod is not paired with WINBOT.
3.The Safety Pod is not attached to the glass safely and firmly.
4.The Safety Pod is pairing with WINBOT.
Continuous GREEN The Safety Pod is working normally. WINBOT can start working.
The Safety Pod's battery is low. Replace the battery as described in
Flashing RED
Section 4.4.
Continuous RED Please refer to Section 6. Troubleshooting, for details.
The Safety Pod's battery is low. Please replace the battery as described
Flashing RED
in Section 4.4.
Continuous GREEN The Safety Pod's battery is sufficient.
Description