Hettich ROTOFIX 46 Mode D'emploi page 6

Standards and regulations which apply to this device
The device is a high-end technical product. It is subject to extensive testing and certification procedures according to
the following standards and regulations in their respectively valid version:
Electrical and mechanical safety for design and final testing:
Standard series: IEC 61010 (conform to standards of DIN EN 61010)

IEC 61010-1 "Safety requirements for electrical equipment for measurement, control, and laboratory use -
Part 1: General requirements" (Pollution Degree 2, Excess-voltage category II)

IEC 61010-2-010 "Safety requirements for electrical equipment for measurement, control and laboratory use
- Part 2-010: Particular requirements for laboratory equipment for the heating of materials" (applied to
heated centrifuges only)

IEC 61010-2-011 „Safety requirements for electrical equipment for measurement, control and laboratory use
- Part 2-011: Particular requirements for refrigerating equipment" (only valid for centriguges with cooling)

IEC 61010-2-020 "Safety requirements for electrical equipment for measurement, control, and laboratory
use - Part 2-020: Particular requirements for laboratory centrifuges"
Electromagnetic Compatibility:

EN 61326-1 "Electrical equipment for measurement, control and laboratory use - EMC requirements - Part 1:
General requirements"
Restriction of Hazardous Substances (RoHS II):

EN 50581 "Technical documentation for assessing electric and electronic devices with regard to the
restriction of hazardous substances"
Certified quality management system according to

ISO 9001 "Quality management systems – Requirements"
Environmental management system according to

ISO 14001 "Environmental management systems - Requirements with guidance for use"
6/102 Rev. 07 / 05.2020 AB4600DEENFRIT