Complete The Installation; Top Assembly - Heath Zenith Secure Home SH-4150-SV Mode D'emploi

1. Stuff the wires into the junction box. Make
sure the wires from the fixture go through
the wire path, and no wires get pinched.
Slide the fixture onto the
mounting screws and
tighten nuts.
2. Caulk fixture mounting surface with
silicone weather sealant.
3. Install one 100 Watt maximum light bulb.
4. If so equipped, install the fixture top.Secure
with decorative screws.
5. If you will not be installing the optional tail
assembly, install the decorative nut onto
the bottom of the fixture now.
200475-02

COMPLETE THE INSTALLATION

Junction
Box

4162 Top Assembly

Optional Assembly
If so equipped, you may install the decorative
tail as shown below.
1. Screw in
extension bar.
Bottom trim piece
has drain hole
5
Larger piece
on top
Hex nut
2. Add tail piece
and trim.
3. Install
decorative nut.