Heath Zenith Secure Home SH-4150-SV Mode D'emploi page 6

TESTING
1. Turn on the circuit breaker and light
switch.
Note: Sensor has a 1
riod before it will detect motion. When
first turned on wait 1
2. Set SENSITIVITY to mid position and
ON-TIME to TEST position.
TEST 1 5 10 MIN
ON-TIME
Avoid aiming the control at:
• Pools of water or objects that change
temperature rapidly, such as heating vents
and air conditioners. These heat sources
could cause false triggering.
• Areas where pets or traffic may trigger
the control.
• Nearby large, light-colored objects
reflecting daylight may trigger the shut-off
feature. Do not point other lights at the
sensor.
6 ft.
(1.8 m)
Maximum Range
/ minute warm up pe-
1
2
/ minutes.
1
2
LO - M - HI
SENSITIVITY
30 ft.
(9.1m)
Maximum
Coverage Angle
The detector is less sensitive to motion di-
rectly towards it and more sensitive to across
motion.
Motion
Least Sensitive
3. Walk through the coverage area noting
where you are when the lights turn on.
Move the sensor head left or right to
change the coverage area. Note: Grasp
the sensor only as shown and turn the
entire sensor. Any other method may
damage the sensor. Do not force it past
the stops.
150°
Rotating Sensor Head to Change Coverage
4. Set the SENSITIVITY as needed. Too
much sensitivity may increase false
triggering.
5. Set the amount of TIME you want the light
to stay on after motion is detected. (1, 5,
or 10 minutes).
6
Motion
Sensor
Most Sensitive
Area
200475-02