Porthole - Vestfrost ULTF 40 VTS098 Notice D'utilisation

EN

Porthole

Portholes are used to pass the temperature
probe or nozzle of a back-up system in the
chamber�
Steps:
1� See chapter ´´Freezer components´´ for
placement of porthole on your device�
2� The rubber plug varies from the models�
Please see the illustrations to the left to
find your type of porthole�
Porthole type 1:
1� Take out the two rubber plugs�
2� Press a pencil through the marks on the
inside of the rubber plugs�
3� Put your external sensor through the
porthole, in the same direction as the
arrow seen on the illustrations to the left
or as described below�
4� Put the sensor through the outer rubber
plug�
5� Then through the foam cylinder inside
the porthole�
6� Then through the inner rubber plug�
7 � Use the cable tie to mount your sensor�
Vestfrost Solutions 19