Porthole - Vestfrost ULTF-37 Notice D'utilisation

18 Vestfrostsolutions.com

Porthole

Porthole is used to pass the temperature
probe or nozzle of a back-up system in the
chamber.
Steps:
1. See chapter ´´Freezer components´´ for
placement of porthole on your device.
2. Take out the two rubber plugs.
3. Press a pencil through the marks on the
inside of the rubber plugs.
4. Put your external sensor through the
porthole, in the same direction as the
arrow seen on the illustrations to the left
or as described below.
5. Put the sensor through the outer rubber
plug.
6. Then through the foam cylinder inside
the porthole.
7 . Then through the inner rubber plug.
8. Use the cable tie to mount your sensor.
EN